From Peace Corps Wiki
A squeak in hardwood flooring is caused by two items of wood rubbing against one another. One way to stop the noise is by decreasing the friction of the moving pieces using a lubricant. Im perhaps not talking oil here, but instead a with ultra-fine graphite powder.
This is offered by the local hardware stores, and for probably the most part its used to free lock systems. But it could very well reduce or get rid of the sound, so that it can perhaps work its way into the squeaking boards if you put a little little bit of it on the floor.
If that fails, you can always here is another set of well-placed claws. You first have to pre-drill some thin holes in to the wood, angled slightly towards the other person. Then get the nails in, being careful never to beat up the wood floor with the mind of the sort.
You need to use an 8d or 8-penny end nail, with a very small head. Then sink it below the outer lining of the wood using a nail set. You will say good-bye compared to that squeak forever. You'd need a little drill bit, a hammer, and a cordless drill. Minutes would be taken no more than 15-20 by this to complete.
Work with a gel stay in the exact same color as the floor to fill any nail opening which are apparent, now after you eliminate all of the squeaks. Youll have the ability to continue its surface for around a quarter of what it would cost to install a brand new floor, whenever your floor is really starting to show its age.
You can sand and refinish them, often up to an overall total of four times before so much wood is floor away that the nails holding it in position start to appear. Your hardwood ground should really be new as good.B & G Hardwood Flooring 3727 Primrose Ave Santa Rosa, CA 95407 (707) 585-6829 http://bghardwoodflooring.net wood flooring discussions